Replacement Of The Lamp - HYOSUNG GT 650 EFI Owner's Manual

2. Loosen the rear axle ① .
3. Carefully position a jack or block under
engine and raise until the rear wheel is
slightly off the ground.
WARNING
A hot muffler can burn you.
The muffler will be hot enough to burn
yor for some time after stopping the
engine.
Wait until the muffler cools to avoid
burns.
4. Draw out the rear axle shaft.
5. Pull the rear wheel assembly rear
ward.
6. To replace the wheel, reverse the com-
plete sequence listed.

REPLACEMENT OF THE LAMP

Requirement electric power of the lamp
shown in the following chart.
When replace the damaged lamp, always
use the equal capacity.
The use of a lamp other than rules may
cause to excessive at the electric system or
to damage the lamp.
NAMES
HI
Head lamp
LO
Position
Brake / Tail lamp
Turn signal lamp
License plate lamp
12V - H4 : 60W × 1
12V - H4 : 55W × 1
12V - W5W × 1
12V - P21/5W × 1
12V - RY10W × 4
12V - W5W × 1
CAPACITY
&
12V - H1 : 55W × 1
12V - H3 : 55W × 1
←
←
←
←
74