HYOSUNG GV 250 EFI Owner's Manual page 45

2. Remove the screws ③
④ .
�
3. Remove the air cleaner element ⑤ .
�
4. Clean the air cleaner element for the
following :
1) When the air cleaner element clean
with the air gun, necessarily blow at
the inside by compressed air.
2) Carefully examine the air cleaner
element for tears during cleaning.
Replace it with a new one if it is torn.
3) Assemble the element completely or
damage severely the engine.
4) Be careful not to allow water to go
inside the air cleaner element.
CAUTION
● ● Assemble the element completely or
damage severely the engine.
● ● Be careful not to allow water to go
inside the air cleaner element.
and take off
Before and during the cleaning
�
operation, inspect the element for tears.
A torn element must be replaced.
Be sure position the element snugly and
correctly, so that no incoming air will
bypass it.
Remember, rapid wear of piston rings
and cylinder bore is often caused by a
defective or poorly fitted element.
● ● When the assembly of air cleaner
● ● Be careful not to allow water to go
More frequent servicing may be
performed on motorcycles that are used
under severe conditions, also clean the
air cleaner element when replacing the
oil to prevent damage of the engine.
44
CAUTION
CAUTION
element is not completely done,
dusts can go inside and damage
severely engine.
into the element while washing.
CAUTION