Updating Sles 8 - Novell SLRS 8 Admin Manual

Table 5.4: Network Configuration of eth0 on the Branch Server
IP Address
Netmask
Host Name
Domain Name berlin1.berlin.mycompany.mycorp.de
Name Server
Table 5.5: Network Configuration of eth1 on the Branch Server
To configure eth1 (the NIC for the external connection to the administration
server), enter the values shown in Table
The values as shown in Tables 5.2, 5.4, and
administration and branch server environment. The administration server and
branch servers communicate on the external network and the POS terminals
communicate with the branch server on the internal network. Enter your own
IP addresses, domain names, etc., for your branch server, corresponding to the
values configured in the LDAP database of the administration server.

5.2.3 Updating SLES 8

The actual version of the SLRS 8 is based on the SLES/UL Service Pack 3
and needs to be updated with the United Linux Service Pack 3 CD1 from the
SLRS 7-CD Set.
To initiate the update, insert the Service Pack CD into the CD drive of the
branch server, mount the CD and call the install_update_rpms.sh script, as
described below:
mount /media/cdrom
Execute: /media/cdrom/install_update_rpms.sh
umount /media/cdrom
Eject the Service Pack CD.
Note: The install scripts for updating RPMs are hard-coded to use /media/cdrom.
If your CD-ROM drive uses a different name to mount (such as /media/cdrecorder),
enter the following commands to create a link to the CD:
cd /media
ln -s cdrecorder cdrom
After installing the Service Pack CD you should reboot the branch server.
5.2 Installation of the Branch Server
IP Address 10.0.0.1
Netmask 255.255.255.0
192.168.2.1
255.255.255.0
127.0.0.1
5.5
5.5
bs1
on page 63.
serve as an example setup of an
63