Novell SLRS 8 Admin Manual page 158

16 Troubleshooting
installation.
Hints
Herefore the United Linux Service Pack would be the solution or an optional
SCSI driver disk from the hardware manufacturer.
For example, booting from the United Linux Service Pack 3 CD1 the United
Linux boot screen is displayed (see Figure 16.1). The selection "Installation"
will start the installation, the selection "Manual Installation"
possibility to add optional drivers, for example SCSI drivers, before the YaST2
installation programm takes over.
During the installation you will be prompted:
Please make sure that CD number 1 is in your drive. Eject the Ser-
vice Pack CD and insert the SLRS CD1. The further installation process
is equal as described in Section
spectively, until to the point before the first reboot of the system, when
you are prompted again to insert the initial Service Pack 3 CD.
Please note, that the step "Updating the SLRS Base Software" must also be
done by installing the Service Pack on your system, before configuring
the administration or branch server software.
1
The selection "Manual Installation" is also offered, installing from the SLRS CD1.
158
Figure 16.1: United Linux Boot Screen
3.2 on page 23 and 3.3
1
provides the
on page 31 re-