Novell SLRS 8 Admin Manual page 41

3.4 Test your SLRS System Environment
Address> and the corresponding directory will be written for this
new CR below the /tftpboot/CR directory of the branch server,
for example, the file config.00:06:29:E3:02:E6 and the directory
00:06:29:E3:02:E6.
The newly registered POS client can be found in LDAP of the admin-
istration server, for example, POS01. To verify the CR entry in LDAP
use again a ldapsearch command or a GUI-based LDAP browser.
– POS client booting fails - CR control file available: In case of failure
verify the hardware type entry of the CR control file hwtype.<MAC
Address>, below the /tftpboot/upload directory of the branch
server with the LDAP settings of the administration server.
Figure 3.6 : Check if the hardware type configured in LDAP
matches the identified hardware type of the used POS client.
Check if the corresponding POS image configured for this
hardware type is available below the /tftpboot/images directory
of the branch server.
Check if the POS image version is enabled in LDAP.
41