Prebuilt Standard Images - Novell SLRS 8 Admin Manual

For example:
SLESCD1=/opt/SLES/dists/ul-sp3/CD1
SLESCD2=/opt/SLES/dists/slrs-i386/CD1
SLESCD3=/opt/SLES/dists/ul-i386/CD1
SLESCD4=/opt/SLES/dists/ul-i386/CD2
SLESCD5=/opt/SLES/dists/ul-i386/CD3
During installation, the imageBuilder checks each CD set to find the packages
needed to create the requested image. The order of the single CD entries is im-
portant. scr looks for the requested package in the same order as the CD spec-
ification in AdminServer.conf. According to the example above, this means
imageBuilder will search the packages from /opt/SLES/dists/ul-sp3/CD1 to
/opt/SLES/dists/ul-i386/CD3.
Note: The processing sequence, as mentioned above, to put the latest pack-
ages into the image starts with SLESCD1. As shown in the example, add the
United Linux Service Pack CD

8.6 Prebuilt Standard Images

A set of standard images is provided with imageBuilder. To install the standard
images described below, perform the following commands
rpm -Uhv POS_Image-Netboot-Binary.rpm
rpm -Uhv POS_Image-DiskNetboot-Binary.rpm
rpm -Uhv POS_Image-Minimal-Binary.rpm
rpm -Uhv POS_Image-Java-Binary.rpm
rpm -Uhv POS_Image-Browser-Binary.rpm
rpm -Uhv POS_Image-Desktop-Binary.rpm
The prebuilt image and checksum files are located in:
/opt/SLES/POS/image
4
SLRS 8 is based on United Linux Service Pack 3, therefore this CD needs to be on top. If
you receive a newer Service Pack CD replace Service Pack 3 with it.
5
Note: The prebuilt standard image packages are installed during the installation of the
administration server.
8.6 Prebuilt Standard Images
4
on the top of all entries.
5
:
103