Installation Of The Branch Server - Novell SLRS 8 Admin Manual

cp /opt/SLES/POS/image/java-1.1.2-2003-12-03 \
/opt/SLES/POS/rsync/image/java-1.1.2
Copy the Java Image MD5 check sum file:
cp /opt/SLES/POS/image/java-1.1.2-2003-12-03.md5 \
/opt/SLES/POS/rsync/image/java-1.1.2.md5
Congratulations! You have installed your Administration Server.

3.3 Installation of the Branch Server

Note: Install the administration server before proceeding with this sec-
tion.
The SLRS software contains 7 CDs, 2 SLRS CD, 3 CDs for United Linux and
2 Service Pack CDs. The installation starts, booting from the first CD (SLRS
CD1). SUSE YaST2 (Yet another Setup Tool) is a powerful graphical system
assistant, which safely guides you through the installation procedure. In many
cases, a few clicks are all that is needed to install SUSE LINUX Retail Solution
on your server.
Note: SUSE recommends to use SLRS CD1 for the installation of the SLRS
software. In some cases, the installation will fail. One problem could arise,
while booting new servers with unsupported SCSI/Raid controllers. For fur-
ther information refer to Section
The YaST2 installation program starts (refer to Figure
after booting from the first CD (SLRS)
Read and accept the SLRS EULA (End User License Agreement).
Select your language.
YaST2 prompts for the installation mode:
– New installation
– Boot installed system
– Abort installation
11
For further information about the installation process, refer to your hardcopy SUSE LINUX
documentation or the SUSE LINUX documentation on your installation CD.

3.3 Installation of the Branch Server

16.1.1 on page 157.
11
.
3.1 on page 23)
31