Table of Contents
Advertisement
BINDING AND CONFIGURING THE L510 F OR L510 T
Configure the L510 with a unique device address and required functionality, and it contains a radio that requires being "bound"
to a specific Room ID, PAN ID, and RF Channel. Use a laptop with the EngINN program installed with a connected PC503 USB
commissioning device to perform this binding and configuration. You can also configure it with an E7, E528/E527.4G
thermostat, or e7w/E529 battery-powered thermostat.
Binding and configuring the L510 from EngInn
Prerequisite
: Create an INNTool project that defines all the required settings for L510.F or L510.T using INNTool in a particular
room and load it into EngINN. It is beyond the scope of this document to fully cover using INNTool/EngINN. Refer to specific
commissioning documentation.
1. Navigate to the Deployment Data section on EngINN and select the desired room and L510.
The Device Summary page opens, displaying the defined settings for the selected L510.
Click the "Bind" button at the bottom to open the Bind Device screen.
2. On the Bind Device screen that appears, click the Start button to make EngINN begin to watch for Bind Request from the
L510.
3. The L510 uses a "Reverse Bind," meaning it will send a Bind Request when you press its Bind /Service button. Do the follow-
ing steps to Bind the L510.
a. Go to the desired L510 and press its Bind/Service button to initiate the Reverse bind. It should send a Bind Request.
b. If EngINN via the PC503 received the Bind request from the L510, it would send a Bind Offer to the L510. If the L510
received this Bind Offer, it will store the settings defined in the Bind Offer, RESET, then, upon startup, send a sound
buzzer message into the room to make any device with a buzzer beep as audible feedback that the L510 was bound.
INCOMM L510 LAMP CONTROLLER USER GUIDE
5
v1.5 October 26, 2022
31-00593-01
Advertisement
Table of Contents
