Error Codes - Kodak S1220 - Photo Scanning System User Manual

Error codes

Error Code Message
Access to destination folder XXXX could not
be set exiting the application.
Burn CD/DVD button is disabled.
10, 11, 12, Failure to communicate with the scanner.
23 Please retry. If this error persists, please
contact Support with error code XX.
105, 106, Failure to communicate with the flatbed
107, 108, scanner. Please retry. If this error persists,
109 please contact support with error code 10X.
110, 111, Image Cleaner Tool failure. Please retry. If
112, 113, this error persists, please contact support
114 with error code 11X.
186 System configuration error. Please contact
Kodak support. Exiting....
1001 Error Code: 1001. Installation error. Could
not fetch image processing defaults. Please
check PrintScan.ini. Exiting...
1002 Error Code: 1002. Could not read image
processing defaults from s1220.Profile.
Continuing with default settings.
1003 Error Code: 1003. s1220 Driver version
incorrect. Refer to s1220 Photo Scanner
User's Guide, Chapter 7 for more
information.
1120 Image Cleaner Tool failure. Please retry. If
this error persists, please contact support
with error code XXXX.
251085: Start error. Kodak s1220 Photo Scanning
1220 System copy protection error. No license
found.
4000 CD/DVD burning is not supported
4001 Please install Windows Feature Pack for
Storage.
4002 Delegate Function error.
A-61601 February 2010
Use the table below as a guide to check possible solutions to problems
you may encounter when using the Kodak s1220 Photo Scanning
System.
Description
Verify that there is a valid Target_Path for the scanned
photos in the PrintScan.ini file.
Run as Administrator or have the administrator give
limited rights users permission to burn CD/DVDs. Refer
to Chapter 7, Application Configuration.
Verify that the s1220 Scanner is attached, turned on and
the green LED is on and steady. If the error persists,
contact Kodak Service.
Verify that the flatbed is attached properly to the s1220
Scanner. If the error persists, contact Kodak Service.
Contact Kodak Service.
If the problem persists, contact Kodak Service.
Verify that a valid PrintScan.ini file exists. Reinstall the
Kodak s1220 Photo Scanning System. Refer to Chapter
2, Installation.
Verify that a valid s1220.Profile file exists. Reinstall the
Kodak s1220 Photo Scanning System. Refer to Chapter
2, Installation.
The s1220 Photo Scanning System software does not
support the i1220 Plus Scanner drivers. Do not install
those drivers for the s1220 Photo Scanning System. To
re-install the s1220 Photo Scanner drivers, turn off the
s1220 Photo Scanner and run the SetupFW_i1200_
v2.23.exe from the i1220 folder on the KODAK s1220
Photo Scanning System Software CD. Reboot the PC
then power on the s1220 Photo Scanner. This will re-
install the correct version of the s1220 Photo Scanner
drivers.
If the problem persists, contact Kodak Service.
Verify that the supplied s1220 USB software dongle is
plugged into a USB 2.0 port on the PC.
• Run as Administrator or have the administrator give
• Verify a CD/DVD burner is installed on the PC.
Refer to Chapter 2, Installation.
Reinstall the Kodak s1220 Photo Scanning System.
Refer to Chapter 2, Installation.
limited rights, users permission to burn CD/DVDs.
Refer to Chapter 7, Application Configuration.
Reinstall the Kodak s1220 Photo Scanning System.
7-5