Operation - Denon AVR-2805 Operating Instructions Manual

3. Video deck (VCR) system buttons
POWER : Power on/standby
(ON/SOURCE)
Channel +, – : Channels
1 : Play
2 : Stop
6,7 : Manual search
(forward and reverse)
3 : Pause
POWER
(ON/SOURCE)
0~9, +10
TV/VCR
TV VOL +, – : Volume up/down
CHANNEL : Switch channels
+, –
MENU
DISPLAY
RETURN
•, ª, 0, 1 : Cursor up, down, left
ENTER
NOTES:
• For this CD, CDR, MD and TAPE components, buttons can be operated in the same way as for Denon audio
components.
• The television can be operated in the DVD/VDP, VCR and TV modes.
4. Monitor TV (TV), digital broadcast satellite
(DBS) tuner and cable (CABLE) system buttons
: Power on/standby
: Channels
: Switch between TV and
video player
: Menu
: Switch display
: Return
and right
: Enter
Learning function
If your AV component is not a DENON product or if it cannot be operated using the preset memory, it can be
controlled with the included remote control unit by storing its remote control signals in the remote control unit.
For some remote control signals it is not possible to "learn" the signals or the device will not operate properly.
In such cases use the remote control unit included with the device to operate it.
1
Press the USE/LEARN button with the tip of a
pen etc., to set the learn mode.
• Both the mode selector buttons and
LEARNED/TX indicator flash.
Flashes
2 Press the mode button of the equipment for
which learning is desired.
• Mode button and LEARNED/TX indicator
flash.
3 Press the button that is to be learned.
The LEARNED/TX indicator stops flashing and
the mode button lights.
• Mode button and LEARNED/TX indicator
flashed if a button that cannot be "learned" is
pressed.
• To cancel, press the USE/LEARN button.
4
Point the remote control units directly at each
other and press and hold in the button on the
other remote control
unit which you
want to "learn".
Other remote
control unit
5 The mode button and the LEARNED/TX
indicator lights, release the button on the other
remote control unit.
• The mode button and
the LEARNED/TX indicator
start flashing again.
ENGLISH
2
1, 3, 7
6
To "learn" other buttons, repeat steps 2 to 5.
7 Once the learning operation is completed, press
the USE/LEARN button again.
The mode button and the LEARNED/TX
indicator stop flashing and the learning mode is
cancelled.
Check that the stored codes
work properly.
NOTES:
• If the codes could not be stored, the
LEARNED/TX indicator start flashing rapidly. For
limited number of models, codes cannot be
stored in RC-975.
• If the mode button and LEARNED/TX indicator
start flashing rapidly, this means that the
memory is already full, and the code you have
just attempted to store was not stored.
To "learn" that code, first perform the resetting
operation. (See page 33.)
31