Denon AVR-2805 Operating Instructions Manual page 13

Before setting up the system
1
Check that all the connections are correct, then turn on the main unit's power.
Setup will not be possible when the unit is set to Pure Direct ON or when the headphones are plugged
in. Therefore, please cancel the mode or reverse the condition.
2
Display the System Setup Menu.
(Remote control unit)
NOTES:
• The System Setup menu composition is of a layered design that includes the related items below the large
table title as contained in the tables of Pages 11 and 12.
• Wherever your position in System Setup, one more press of the System Setup button permits a move to
one level higher.
Auto setup/Room EQ
The Auto Setup function of this unit performs an analysis of the speaker system and measures the acoustic
characteristics of your room to permit an appropriate automatic setting.
When performing Auto Setup, a microphone is required for the setup.
Measurement and setting details
2
q Speaker Config.: This sets the speaker connection mode, polarity, and bass reproduction ability.
w Delay Time
: This sets the optimum delay time from each speaker corresponding to the listening position.
e Channel Level : This sets the volume that is output from each speaker.
r Room EQ
: This sets the frequency response of each speaker.
NOTE:
• A loud test tone is output during the measurement. Please consider this should you be planning nighttime
measurements, and consider not allowing small children into the listening room at this time.
Connecting the microphone for Auto Setup
1
Connect the microphone for Auto Setup to the
Setup Mic connector on the front panel of the
unit.
MODE ANALOG EXT. IN
2
Place the microphone for Auto Setup at the
actual listening position which will be at the
same height as your ears. Use a tripod or level
surface at positioning.
NOTE:
• When using other microphone. (See page 16)
Listening position
1
Setting the Auto Setup / Room EQ
1
Select "Auto Setup / Room EQ" at the System Setup
Menu.
(Remote control unit)
2
Display the Auto Setup / Room EQ menu.
(Remote control unit)
1-1 Setting the Auto Setup
1
Select "Auto Setup" at the Auto Setup / Room EQ
Menu.
(Remote control unit)
2
Display the Auto Setup screen.
(Remote control unit)
3
Check the "Power Amp Assign" setting.
• When "Surround Back" is selected, the test tone during Auto Setup will be output from the
Surround Back speaker.
• When "ZONE2" is selected, change the setting to "ZONE2". The test tone during Auto Setup is set
so that it will not be output to ZONE2 (Another room).
q Select the Power Amp Assign setting.
(Remote control unit)
ENGLISH
w Select "Surround Back" or "ZONE2".
(Remote control unit)
NOTE:
• When "ZONE2" is selected at System
Setup Menu "Power Amp Assign",
surround back speaker is not displayed as
the target of setup in "2-1. Speaker
Config.". The results is reflected in "5-1.
Power Amp Assign".
13