Denon AVR-2805 Operating Instructions Manual page 32

ENGLISH
System call
The accessorious remote control unit is equipped with "system call" function allowing a series of remote control
signals to be transmitted by pressing a single button.
This function can be used for example to turn on the amplifier's power, select the input source, turn on the
monitor TV's power, turn on the source component's power and set the source to the play mode, all at the touch
of a button.
(1) System call buttons
Up to 10 signals each can be stored at the
"CALL1" and "CALL2" buttons.
(2) Storing system call signals
1 Press the power ON/SOURCE button and the
OFF button at the same time.
• The LEARNED/TX indicator flashes.
2 Press the CALL 1 button.
• The mode selector buttons and LEARNED/TX
indicator flash.
3 Press the mode buttons of the equipment that
is to be registered to System Call.
4 Press the buttons whose remote control signals
you want to store one by one.
5 Repeat steps 3 and 4 to register the desired
buttons.
6 Press the CALL1 or CALL2 button and register
System Call.
(3) Using the system call function
1 Press the button at which the system call
signals have been stored.
• The stored signals are
successively.
32
1
3
2, 6
6
NOTES:
• The remote control signals for the buttons
pressed while storing the system call signals are
transmitted when the buttons are pressed, so
cover the remote sensor or take other measures
so that the components do not operate while
the signals are being stored.
• The mode button and LEARNED/TX indicator
transmitted
flashing rapidly if you have already stored the
maximum number of signals.
Punch Through
(1) Punch through button
Buttons used in the CD, CDR/MD, TAPE,
DVD/VDP, and VCR modes can be assigned to the
buttons shown on the diagram at the right which
are not normally used in the TV and DBS/CABLE
modes.
For example, when the CD mode is set to the
punch through mode in the TV mode, the CD
mode's PLAY, STOP, MANUAL SEARCH, AUTO
SEARCH, PAUSE and DISC SKIP buttons' signals
are sent in the TV mode.
(2) Making the punch through setting
1 Press the power ON/SOURCE button and the
OFF button at the same time.
1
• The LEARNED/TX indicator flashes.
2
Press the 1 (play) button.
• TV and DBS/CABLE mode buttons and
LEARNED/TX indicator flash.
3 Press the mode button of the equipment for
which Punch Through is to be set.
• The CD, CDR/MD, TAPE, DVD/VDP, and VCR
mode buttons and LEARNED/TX indicator will
flash.
4 Press the mode button of the equipment that is
to be punched through.
• The mode button that was set will light.
1 1
4
3
2