Connecting Multi Zone Jacks - Denon AVR-2805 Operating Instructions Manual

Connecting the antenna terminals
AM LOOP ANTENNA
DIRECTION OF
BROADCASTING
STATION
FM ANTENNA
75 Ω/ohms
COAXIAL
CABLE
FM INDOOR
ANTENNA
GROUND
(Supplied)
• An F-type FM antenna cable plug can be connected
directly.
Notes:
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM loop antenna.
• Make sure AM loop antenna lead terminals do not touch metal parts of the panel.
Connecting the external input (EXT. IN) jacks
• These jacks are for inputting multi-channel audio signals from an outboard decoder, or a component with a
different type of multi-channel decoder, such as a DVD Audio player, a multi-channel SACD player, or other
future multi-channel sound format decoder.
• When making connections, also refer to the operating instructions of the other components.
Decoder with 8- or 6-channel
analog output
For instructions on playback using the external input (EXT. IN) jacks. (See page 35)
AM loop antenna assembly
(Supplied)
Connect to the AM
antenna terminals.
1 2
3
Remove the vinyl tie
Bend in the reverse
and take out the
direction.
connection line.
4
a. With the
antenna on
top any
stable
Mount
surface.
b. With the
antenna
attached to
AM OUTDOOR
a wall.
ANTENNA
Installation hole Mount on wall, etc.
Connection of AM antennas
1. Push the 2. Insert the 3. Return the
lever. conductor. lever.
R R
L L
R R
L L
R R L L
Connecting the MULTI ZONE jacks
For instructions on operations using the MULTI ZONE FUNCTIONS. (See pages 38, 39)
[1] ZONE2 preout CONNECTIONS
• If another power amplifier or pre-main (integrated) amplifier or is connected, the ZONE2 preout (variable/fixed
level) jacks can be used to play a different program source in ZONE2 the same time. (See page 38)
• The ZONE2 video out is only for the ZONE2.
ZONE2
Integrated pre-main amplifier
or power amplifier
B
Extension jacks for future use.
CONTROL terminal
Perform the following operation before using an external controller connected to the RS-232C
terminal:
1. Press the ON/STANDBY button on the main unit and set the unit to the operating mode.
2. Perform the operation to turn off the power from the external control.
3. Check that the product has been set to the standby mode.
After checking the above, check the connections of the external controller. Operation is
possible.
INFRARED
INFRARED RETRANSMITTER
SENSOR
OUTPUT INPUT
+ +
AUX OUT
L
R
ENGLISH
7