Changing The Boot Mode - H3C S5800-32F Installation Manual

7. Skip current configuration file
8. Set BootRom password recovery
9. Set switch startup mode
0. Reboot
If you perform no operation or press a key other than Ctrl + B within one second, once the
remaining waiting time becomes zero, the system begins to automatically start up and the following
information is displayed:
Starting to get the main application file--flash:/S5800_release.bin............
The main application file is self-decompressing................................
...............................................................................
...............................................................................
...............................................................................
...............................................................................
..........................Done!
System is starting...
Board checking.......................LSW15856C
SDRAM fast selftest........................OK!
Flash fast selftest........................OK!
CPLD selftest..............................OK!
Switch chip selftest.......................OK!
PHY selftest...............................OK!
Please check leds....................FINISHED!
User interface aux0 is available.
Press ENTER to get started.
The appearance of "Press ENTER to get started" indicates that the automatic startup of the switch is
complete.
Press Enter. The following prompt is displayed:
<H3C>
You can configure the switch now.

Changing the Boot Mode

By default, the system starts up in normal boot mode. If you want to change the boot mode to fast, press
Ctrl + B within five seconds to enter the Boot ROM menu showed below:
BOOT MENU
1. Download application file to flash
2. Select application file to boot
Item
Skip the current configuration file (this configuration is valid
once)
Restore the Boot ROM password
Set the startup mode of the switch
Restart the switch
Description
4-7