100/1000Base-X Sfp Interface Status Led - H3C S5800-32F Installation Manual

Port mode
LED
Flashing green
(1 Hz) (PoE
mode,
supported by
PoE switches
only)
Steady yellow
(duplex mode)

100/1000Base-X SFP Interface Status LED

The port mode LED and the 100/1000Base-X SFP interface status LED together indicate the SFP
interface operation status. Refer to
Table 1-16 100/1000Base-X SFP interface status LEDs description
Status
Port mode
LED
Steady green
(rate mode)
Steady yellow
(duplex mode)
Status
Ethernet port status
LED
Steady green
Flashing green (3 Hz)
Steady yellow
Flashing yellow (3 Hz)
Off
Steady green
Steady yellow
Flashing yellow (3 Hz)
Off
Table 1-16
Ethernet port
status LED
The port operates at a rate of 1000 Mbps; the LED is fast
Steady green
flashing when data is being sent and/or received on the port.
The port operates at a rate of 100 Mbps; the LED is fast
Steady yellow
flashing when data is being sent and/or received on the port.
Flashing yellow
POST failed on the port.
(3 Hz)
Off No link is present on the port.
The port operates in full-duplex mode; the LED is fast flashing
Steady green
when data is being sent and/or received on the port.
Flashing yellow
POST failed on the port.
(3 Hz)
Off No link is present on the port.
Description
PoE power supply is normal.
Power consumption of the device connected to the port
exceeds the upper limit of the power supply
consumption of the port, or the available power of the
switch is not enough for power supply of the port.
PoE failure, and power supply failed.
POST failed on the port.
The port does not provide PoE power.
The port operates in full-duplex mode; the LED is fast
flashing when data is being sent and/or received on the
port.
The port operates in half-duplex mode; the LED is fast
flashing when data is being sent and/or received on the
port.
POST failed on the port.
No link is present on the port.
for details.
Description
1-21