Trim; Idle Management: Thr-Cut - FUTABA 7C-2.4GHZ Instruction Manual

Engine idle management: THR-CUT: Functions which work with the digital T
consistent means of engine operation. No more fussing with getting trim in just the right spot for landings!
Throttle cut (TH-CUT) (ACRO/HELI): Provides an easy way to stop the engine by flipping a switch (with T
at idle). The movement is largest at idle and disappears at high throttle to avoid accidental dead sticks. In HELI, there is an
additional setting, TH-CUT See p. 66.
GOAL of EXAMPLE:
Decrease the throttle setting (at idle) to
stop the engine with the flip of a switch.
(default: S A in the down
WITCH
position)
Where next?
*Normally, a setting of 10-20% is sufficient. Viewing the carburetor barrel until it fully closes is adequate to get an approximate setting; then test with
engine running to confirm.
STEPS:
Open BASIC menu, then open
THR-CUT function.
Activate the function. Choose desired
switch, and the position which
activates the function.
With T S at idle, adjust the
HROTTLE TICK
rate until the engine consistently shuts
off but throttle linkage is not binding.*
Close.
Set up dual/triple rates and exponential (D/R,EXP): see p. 33.
Set up TRAINER functions: see p. 37.
Set up twin aileron servos: see p. 42.
32
T to provide a simple,
HROTTLE RIM
INPUTS:
for 1 second.
(If
ADVANCE,
to THR-CUT.
to ON(OFF).
to SW.
to select the desired
switch and position.
A to down position.
T S
HROTTLE TICK
to RATE.
S
HROTTLE TICK
again.)
.
until shuts off.