FUTABA 7C-2.4GHZ Instruction Manual page 69

• Revo. mixing rates are linear curves. For a clockwise-turning rotor, the rudder is mixed in the clockwise direction
when collective pitch is increased; for counterclockwise-turning, the opposite. Change the operating direction setting
by changing the signs of the numbers in the curve from plus (+) to minus (-) and vice versa.
• Revo. curves for idle-ups are often v-shaped to provide proper rudder input with negative pitch and increased throttle
during inverted flight. (Rudder is needed to counter the reaction whenever there is increased torque. In inverted flight,
throttle stick below half has increased throttle and negative pitch, therefore increasing torque and rotating the
helicopter unless the revo. mix is also increasing appropriately.)
IDLE-UPS: Additional flight conditions available specifically for helicopters. These additional flight conditions contain
different throttle curves, collective pitch curves, and trims to make the helicopter perform
certain maneuvers more easily. Lastly, the gyro and dual rate functions may be set to provide separate rates per condition
selected, including one for each idle-up.
One of the most common flight conditions can easily flip from upright to inverted and back. To do so, the pitch curve is
set to 0 pitch at half stick, positive pitch (climb upright) above half, and negative pitch (climb when inverted) below half
stick. The throttle curve is adjusted to allow the engine to run consistently throughout the changes in pitch.
Additional idle-ups may be used to maximize the helicopter's flight characteristics in certain types of flight (i.e. fast
forward motion, backward) or maneuvers (loops, rolls, stall turns), or even the same maneuver but changing from heading-
hold/AVCS gyro mode to normal gyro mode. The 7C provides 2 idle-ups to allow the modeler 2 additional setups along
with the normal flight condition.
Adjustability:
• S G (7CA) or E (7CH) is programmed for normal (NORM), idle-up 1 (IDL1), and idle-up 2 (IDL2) curves. This
WITCH
switch/position assignment is not adjustable.
• Activated with the throttle curve for that condition in THR-CURVE.
• Curves are adjusted to maintain constant RPM even when the collective pitch is negative (inverted).
• Gyro settings may be set separately for each idle-up. (See p. 73.)
• Activating OFFSET makes the T
• Dual rates may be set up to allow tri rates - a rate for each of the 3 primary controls in normal/idle up conditions.
For an example of throttle and pitch curves and revo, please see Normal Flight Condition Setup, p. 65.
adjust the trim separately in each of the idle-up conditions.
L
RIM EVERS
69