Setting Up The Normal Flight Condition - FUTABA 7C-2.4GHZ Instruction Manual

Setting up the Normal Flight Condition: The Normal flight condition is typically utilized for hovering. The throttle and
collective pitch curves are adjusted to provide consistent engine RPM despite the increase/decrease in collective pitch of
the blades. This keeps the engine from "bogging down" under excessive load (like trying to accelerate a car on a steep hill
in 5th gear) or excessive RPM under insufficient load (like flooring the throttle while in neutral), risking engine damage.
As the 2 curves and revo. mixing are all interrelated, we will discuss all three first, then complete a sample setup.
Note that the normal throttle and pitch curves and revo mix are all available in the BASIC menu for simplicity. These may also be
updated later in the ADVANCE menu with the settings for the other 3 conditions [idle-up 1 (IDL1), idle-up 2 (IDL2) and throttle
hold (HOLD)]. Note: The throttle and pitch curves for the normal condition are always on. They cannot be inhibited. The
other three conditions are activated with their throttle curves or throttle hold. For idle-ups, see p. 69. For throttle hold, see p. 67.
• TH-CV/NOR: Inputs the normal (NORM) throttle curve, which is usually not a linear response to T
Adjusting point 3 of the curve adjusts the engine's RPM at the T
hovering. The other 4 points are then adjusted to create the desired idle and maximum engine speed, and a smooth
transition in-between. For more on throttle curves, see p. 69.
• PI-CV/NOR: Inputs the normal (NORM) collective pitch curve, the collective pitch curve for flight near hover. The
normal collective pitch curve is adjusted to match the throttle curve, providing the best vertical performance at a
constant engine speed, with a starting curve of -4 base, +5 neutral, and +8 to +10 degrees of blade pitch maximum*.
You can program the response over a 5-point curve for the best collective pitch angle relative to T
movement. For more on collective pitch curves, see p. 69.
• REVO.: Mixes collective pitch commands to the rudder (a PITCH-RUDDER mix) to suppress the torque generated by
changes in the main rotor's collective pitch angle, keeping the model from yawing when throttle is applied. REVO.
is extremely helpful in "taming the tail" of models not using heading-hold/AVCS gyros. Never use revo. mixing
in conjunction with a heading-hold/AVCS gyro while in heading-hold/AVCS mode.
Revo. mixing is still used with these gyros while set to the normal mode. For details on revo, including default points
for clockwise and counterclockwise rotating rotors, see p. 69.
*These default recommendations assume you are doing forward flight. If you are just learning, please follow your instructor's guidance. Some
instructors like a +1 base point for training so that the helicopter comes down very slowly, even if your instincts pull the throttle/collective stick to
the bottom in a hurry.
S
HROTTLE TICK
65
S
HROTTLE TICK
midpoint - the desired position for
HROTTLE
motion.
S
TICK