FUTABA 7C-2.4GHZ Instruction Manual page 28

PARAMETER submenu: sets those parameters you would likely set once, and then not disturb again.
First it is important to clear out any old settings in the memory from prior use, using the MODEL RESET.
MODEL RESET: completely resets all data in the individual model you have currently selected. Don't worry - there is no way
you can accidentally delete all models in your radio with this function. Only a service center can completely reset your
radio's entire memory at once. To delete each model in your radio's memory (for example when selling), you must SELECT
each model, reset that memory, then go SELECT the next memory, etc.
Note that when you COPY one model memory into another or change the model's type, you need not delete all existing data
first by using this function. COPY completely overwrites anything in the existing model memory, including MODEL NAME.
The MODEL TYPE function overwrites all data except name.
GOAL of EXAMPLE:
Reset model memory 1.
NOTE: This is one of several
functions for which the radio requires
confirmation to make a change.
Where next?
*Radio shows progress on screen as the model memory is being reset. Note that if the power switch is turned off prior to completion,
the data will not be reset.
Once you have selected the correct model you wish to work with, the next step is
setting up the proper parameters for this specific model:
•
What is the model's type?
•
Assign the desired SW to CH5 and CH7.
STEPS:
Confirm you are currently using the
proper model memory. (Ex: 1)
Open PARAMETER submenu.
Reset the Memory.
Confirm the change.
Close.
Now that the memory is reset, name has returned to the default (Ex: MDL-01).
NAME the model: p. 27.
COPY a different model into this memory: p. 25.
SELECT a different model to edit or delete: p. 25.
Change the MODEL TYPE to helicopter: see p. 28.
Utilize servo REVERSE: see p. 30.
Adjust servo travel with END POINT: see p. 31.
Set up dual/triple rates and exponential (D/R,EXP): see p. 33.
28
INPUTS:
On home screen, check model name and
number on top left and right. If it is not
correct, use MODEL SELECT, p. 25.
for 1 second.
(If
ADVANCE,
to 3rd page of menu.
to PARAMETER.
for one second.
sure? displays. *
again.)