FUTABA 7C-2.4GHZ Instruction Manual page 33

Dual/triple rates and exponential (D/R,EXP): assigns adjusted rates and exponential.
Activation:
•
Any S , A-H. If you choose a 3-position switch, then that dual rate instantly becomes a triple rate (see example).
WITCH
•
Stick position (ACRO ). (Ex: On rudder you normally use only the center 3/4 of the stick movement except
for extreme maneuvers such as snaps/spins/stalls. As long as your R
throw, the rudder responds at your lower rate, allowing small, gentle corrections. When the stick passes 90% (ie. stall
turn), the rudder goes to high rate's 90%, which is a MUCH higher amount of travel than your low rate at 89%.)
100% 90% 0%
High Rate Low Rate
0% 30%
Low Rate
Exponential: Changes the response curve of the servos relative to the stick position to make flying more pleasant. You
can make the servo movement less or more sensitive around neutral for rudder, aileron, elevator, and throttle (except HELI
type - use THROTTLE CURVE instead).
Why use expo? Many models require a large amount of travel to perform their best tricks. However, without exponential,
they are "touchy" around neutral, making them unpleasant to fly and making small corrections very difficult. Additionally,
by setting different exponentials for each rate, you can make the effectiveness of small corrections similar in each rate, as
in our example below.
The best way to understand exponential is to try it:
•
Having made no changes yet in the D/R,EXP screen, move S
•
Cursor down to EXPand dial to 100%.
•
Move S D up. Hold the A
WITCH
•
Notice how much less travel there is.
•
Go to 3/4 stick and repeat. Notice how the travel is much closer, if not identical.
Dual/Triple Rates: Reduce/increase the servo travel by flipping a switch,
or (ACRO ) they can be engaged by any stick position. Dual rates affect the control
listed, such as aileron, not just a single (ex: channel 1) servo. For example, adjusting
aileron dual rate will affect both aileron servos when using FLAPERON, ELEVON, and
a CCPM helicopter.
EPA = 1"
Ex:
At 89%
At 90%
90% 100%
High Rate
100%
High Rate
S
ILERON TICK
UDDER
Low Rate = 50%
Low Rate = .45"
Adjustability:
•
Range: 0 - 140% (0 setting would deactivate the control completely.)
Initial value=100%
D to "down" (toward the A
WITCH
at 1/4 stick and move S
WITCH
33
S does not exceed 90% of maximum
TICK
High Rate = 100%
High Rate = .9"
ILERON
D down.
S ).
TICK