FUTABA 7C-2.4GHZ Instruction Manual page 76

Adjustability:
Speed switching and governor ON/OFF may be used together on one switch.
Speed setting control uses CH7.
The GV-1 controls throttle when it is active, so the throttle will not obey any FailSafe settings preset for throttle in
the transmitter. Always set the FailSafe setting for the GV-1's on/off channel to OFF. This way the governor is shut
off and the throttle obeys the FailSafe throttle commands.
Setting example: When speed and ON/OFF are using one switch:
Governor Speed
RS1: OFF
RS2: 1400
RS3: 1700
The relationship of the governor speed setting rS1~rS3 and the switch positions conforms to the table above.
In throttle hold, always check that the governor is off. If the speed value rises in throttle hold, reverse the "DIR" setting
from +LIMIT to -LIMIT or vice versa.
Expert Tip: Mounting the GV-1 to the counter gear instead of the fan
dramatically simplifies installation in many models.
Switch Position
(Switch B or E)
Up or NORM
CNTR or IDL1
DOWN or IDL2
Rate (%)
0
50
100
76
Adjustment from Tx.
Use up to 0%. (Governor
speed display reads "off".)
Speed adjusted by raising
and lowering rate.
Speed adjusted by
lowering rate.