FUTABA 7C-2.4GHZ Instruction Manual page 13

Charging jack
Battery connector location
NOTE: If you need to remove or replace the transmitter battery, do not pull on its wires to remove it. Instead,
gently pull on the connector's plastic housing where it plugs into the transmitter.
SWITCH ASSIGNMENT TABLE
•
The factory default functions activated by the switches and knobs for a Mode 2 transmitter are shown below.
•
Most 7C functions may be reassigned to non-default positions quickly and easily.
•
Basic control assignments of channels 5 & 7 are quickly adjustable in PARA (see p. 28). For example, the channel 5
servo, which defaults to S
rudder servo in a mix, or to a dial for bomb door or other control.
•
Note that most functions need to be activated in the programming to operate.
•
Mode 1 transmitter functions are similar but reverse certain switch commands. Always check that you have the desired
switch assignment for each function during set up.
Switch/Knob
A or H Tx.
S A
WITCH
Switch B
S D
WITCH
Switch E
G*
OR
Switch F
H*
OR
S G E*
WITCH OR
K VR
NOB
* On the 7CA (mode 2) transmitters, the Top Left Switches are spring-loaded switch and 2-position switch. On the 7CA (mode 1) and 7CH
transmitters, the Top Left Switch is a 3-position with the spring loaded switch on the top right.
Ni-Cd battery pack
Battery cover
E for retract use, can easily be unassigned (NULL) to allow for easy use as a second
WITCH
Airplane (ACRO)
elevator dual rate
rudder dual rate
aileron dual rate
landing gear/ch 5
snap roll/trainer
up = ELE-FLP on
down = AIRBRAKE
on
flap/ch 6
(flap trim if FLAPERON on)
LED indication
LED
When the transmitter is powered up, the LEDs on
the rear of the transmitter will begin to glow or
blink accordingly. The chart below provides you
with an easy reference as to the meaning of the
Trainer connector
LEDs.
Green
Solid
Alternate blink
Solid
Solid
Helicopter (HELI)
elevator dual rate
rudder dual rate
aileron dual rate
throttle hold
trainer
idle-up 1 and 2,
ch5/OFFSET/GYRO
HOVERING PIT
13
Red Status
Solid Initializing (When Power Up)
Check RF condition nearby
Off RF power on
RF power on (Power reduced to perform the
Blink
range check function.)