FUTABA 12FG Instruction Manual page 54

FREQUENCY
Frequency setting
The T12FG transmitter uses a synthesizer
system. Its frequency can be changed within the
range of the frequency band of the module used.
The frequency of the R5114DPS receiver is set
from the transmitter. Use a receiver matched to the
frequency band of the transmitter.
Receiver ID code
When the R5114DPS receiver (PCM-G3
receiver) is used, the ID code located on the back
of the receiver case must be entered.
*When two receivers are used with a large model, etc., enter
the 2nd receiver ID also.
Modulation mode selection
With the T12FG, 3 modulation modes (PCM-G3/
PCM1024/PPM (FM)) can be selected. Select the
modulation mode matched to the type of receiver
used.
EDIT
Frequency switching method
For a description of the frequency switching and
ID setting methods, refer to the procedure given in
the Basic Operation section.
Modulation scheme (Modulation) change
*The modulation selection screen appears.
SURE?" appears.
*Transmission stops and a transmit or do not transmit in the
54
<Functions of Linkage Menu>
PCM-G3 communication mode selection
Two types of PCM-G3 communication modes
can be selected. (Mode A and Mode B)
Mode A is conventional mode and displays the
maximum performance of the servo response to
stick operation (recommended.) Mode B is a mode
with enhanced communication quality. For the
interference characteristic, ModeB is better than
ModeA. In communication mode B, the servo
response to stick operation is approximately 20%
lower than that of mode A.
C h o o s e t h e m o d e m a t c h e d t o t h e u s a g e
environment.
S1 button
EDIT dial
EDIT button
*When the mode is changed from the PCM-G3 mode to
to the wing type used, the mode cannot be changed.
Receiver ID code input
*Input the 8-digit ID number indicated on the receiver case.
*If you make a mistake, select [BACK SPACE] with the
EDIT dial and erase the incorrect digit by pressing the EDIT
button.
S1
E D I T