Setting method
Curve setting examples
The screens shown below are curves created
by entering the pitch rate at low, center, and high
side (3 points or 5 points) at each condition. When
the fuselage (or the reference value).
Normal Curve
Pitch Trim (Hovering pitch, high pitch, low pitch)
The hovering pitch, low pitch, and high pitch trim setup screen can be called from the PIT Curve setup
screen.
108
<Functions of Model Menu (Helicopter Functions)>
*For a description of the curve setting method, see the
Idle-up 1 Curve
Idle-up 2 Curve
description at the back of this manual.
Hold Curve
(Continued on next page)