Configuring Customized System Messages For Cisco Unified Ip Phones - Cisco CP-7911G-CH1 System Administrator Manual

How to Set Up Cisco Unified IP Phones

Configuring Customized System Messages for Cisco Unified IP Phones

Use the system message command to customize the system message displayed on all Cisco Unified IP
Phones during Cisco Unified CM fallback.
One of two keywords, primary and secondary, must be included in the command. The primary
keyword is for IP phones that can support static text messages during fallback. The default display
message for primary IP phones in fallback mode is "CM Fallback Service Operating."
The secondary keyword is for Cisco Unified IP Phones that do not support static text messages and have
a limited display space. Secondary IP phones flash messages during fallback. The default display
message for secondary IP phones in fallback mode is "CM Fallback Service."
Changes to the display message will occur immediately after configuration or at the end of each call.
The normal in-service static text message is controlled by Cisco Unified Communications Manager.
Note
SUMMARY STEPS
1.
2.
3.
DETAILED STEPS
Command or Action
Step 1
call-manager-fallback
Example:
Router(config)# call-manager-fallback
Step 2
system message {primary primary-string |
secondary secondary-string}
Example:
Router(config-cm-fallback)# system message
primary Custom Message
Step 3
exit
Example:
Router(config-cm-fallback)# exit
Cisco Unified SCCP and SIP SRST System Administrator Guide
94
call-manager-fallback
system message {primary primary-string | secondary secondary-string}
exit
Setting Up Cisco Unified IP Phones using SCCP
Purpose
Enters call-manager-fallback configuration mode.
Declares the text for the system display message on IP
phones in fallback mode.
primary primary-string: For Cisco Unified IP Phones
•
that can support static text messages during fallback,
such as the Cisco Unified IP Phone 7940 and Cisco
Unified IP Phone 7960 units. A string of approximately
27 to 30 characters is allowed.
secondary secondary-string: For Cisco Unified IP
•
Phones that do not support static text messages, such as
the Cisco Unified IP Phone 7910. A string of
approximately 20 characters is allowed.
Exits call-manager-fallback configuration mode.
OL-13143-04