Setting Video Parameters; Contents; Prerequisites For Setting Video Parameters - Cisco CP-7911G-CH1 System Administrator Manual

Setting Video Parameters

Revised: February 3, 2011
This chapter describes how to set video parameters for a Cisco Unified Survivable Remote Site
Telephony (SRST) Router.

Contents

•
•
•
•
•
•

Prerequisites for Setting Video Parameters

•
•
•
•
•
OL-13143-04
Prerequisites for Setting Video Parameters, page 257
Restrictions for Setting Video Parameters, page 258
Information About Setting Video Parameters, page 258
How to Set Video Parameters for Cisco Unified SRST, page 261
Troubleshooting Video for Cisco Unified SRST, page 270
Where to Go Next, page 270
Ensure that you are using Cisco Unified SRST 4.0 or a later version.
Ensure that you are using Cisco Unified CM 4.0 or a later version.
Ensure that the Cisco IP phones are registered with the Cisco Unified SRST router. Use the show
ephone registered command to verify ephone registration.
Ensure that the connection between the Cisco Unified Video Advantage application and the
Cisco Unified IP phone is up.
From a PC with Cisco Unified Video Advantage 1.02 or a later version installed, ensure that the line
between the Cisco Unified Video Advantage and the Cisco Unified IP phone is green. For more
information, see Cisco Unified Video Advantage End User Guides.
Ensure that the correct video firmware is installed on the Cisco Unified IP phone. Use the show
ephone phone-load command to view current ephone firmware. The following lists the minimum
firmware version for video-enabled Cisco Unified IP phones:
Cisco Unified IP Phone 7940G version 6.0(4)
–
Cisco Unified IP Phone 7960G version 6.0(4)
–
Cisco Unified IP Phone 7970G version 6.0(2)
–
Cisco Unified SCCP and SIP SRST System Administrator Guide
257