Cisco CP-7911G-CH1 System Administrator Manual page 263

Setting Video Parameters
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
show running config
Example:
Router# show running config
Step 3
show call-manager-fallback all
Example:
Router# show call-manager-fallback all
Use the Settings display on the Cisco Unified IP phones in your network to verify that the default router
Note
IP address on the phones matches the IP address of the Cisco Unified SRST router.
Examples
The following example shows output from the show call-manager-fallback all command:
Router# show call-manager-fallback all
CONFIG (Version=3.3)
=====================
Version 3.3
For on-line documentation please see:
www.cisco.com/univercd/cc/td/doc/product/access/ip_ph/ip_ks/index.htm
ip source-address 10.1.1.1 port 2000
max-video-bit-rate 384(kbps)
max-ephones 52
max-dn 110
max-conferences 16 gain -6
dspfarm units 0
dspfarm transcode sessions 0
huntstop
dialplan-pattern 1 4084442... extension-length 4
voicemail 6001
moh music-on-hold.au
time-format 24
date-format dd-mm-yy
timezone 0 Greenwich Standard Time
call-forward busy 6001
call-forward noan 6001 timeout 8
call-forward pattern .T
transfer-pattern .T
keepalive 45
timeout interdigit 10
timeout busy 10
timeout ringing 180
caller-id name-only: enable
Limit number of DNs per phone:
OL-13143-04
How to Set Video Parameters for Cisco Unified SRST
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Displays the entire contents of the running configuration
file.
Displays the detailed configuration of all Cisco Unified IP
phones, directory numbers, voice ports, and dial peers in
your network while in fallback mode.
Cisco Unified SCCP and SIP SRST System Administrator Guide
263