Configuration Examples For Cisco Unified Sip Srst Features Using Redirect Mode - Cisco CP-7911G-CH1 System Administrator Manual

Configuration Examples for Cisco Unified SIP SRST Features Using Redirect Mode

DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
voice service voip
Example:
Router(config)# voice service voip
Step 4
sip
Example:
Router(config-voi-srv)# sip
Step 5
redirect contact order [best-match | longest-
match]
Example:
Router(conf-serv-sip)# redirect contact order
best-match
Step 6
end
Example:
Router(config-serv-sip)# end
Configuration Examples for Cisco Unified SIP SRST Features
Using Redirect Mode
This section provides the following configuration example:
•
Cisco Unified SCCP and SIP SRST System Administrator Guide
278
Cisco Unified SIP SRST: Example, page 279
Appendix A: Configuring Cisco Unified SIP SRST Features Using Redirect Mode
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Enters voice service configuration mode.
Enters SIP configuration mode.
Sets the order of contacts in the 300 Multiple Choice
message. The keywords are defined as follows:
best-match—(Optional) Uses the current system
•
configuration to set the order of contacts.
• longest-match—(Optional) Sets the contact order by
using the destination pattern longest match first, and
then the second longest match, the third longest match,
and so on. This is the default.
Returns to privileged EXEC mode.
OL-13143-04