Cisco CP-7911G-CH1 System Administrator Manual page 160

How to Configure Cisco Unified SCCP SRST
DETAILED STEPS
Command or Action
Step 1
call-manager-fallback
Example:
Router(config)# call-manager-fallback
Step 2
cor {incoming | outgoing} cor-list-name
[cor-list-number starting-number -
ending-number | default]
Example:
Router(config-cm-fallback)# cor outgoing
LockforPhoneC 1 5010 – 5020
Step 3
exit
Example:
Router(config-cm-fallback)# exit
Examples
The following example shows how to set a dial-peer COR parameter for outgoing calls to the
Cisco Unified IP Phone dial peers and directory numbers created during fallback:
call-manager-fallback
cor outgoing LockforPhoneC 1 5010 - 5020
The following example shows how to set the dial-peer COR parameter for incoming calls to the Cisco IP
phone dial peers and directory numbers in the default COR list:
call-manager-fallback
cor incoming LockforPhoneC default
The following example shows how sub- and super-COR sets are created. First, a custom dial-peer COR
is created with names declared under it:
dial-peer cor custom
name 911
name 1800
name 1900
name local_call
Cisco Unified SCCP and SIP SRST System Administrator Guide
160
Purpose
Enters call-manager-fallback configuration mode.
Configures a COR on dial peers associated with directory
numbers.
incoming: COR list to be used by incoming dial peers.
•
outgoing: COR list to be used by outgoing dial peers.
•
cor-list-name: COR list name.
•
• cor-list-number: COR list identifier. The maximum
number of COR lists that can be created is 20,
comprised of incoming or outgoing dial peers. The
first six COR lists are applied to a range of directory
numbers. The directory numbers that do not have a
COR configuration are assigned to the default COR
list.
starting-number - ending-number: Directory number
•
range; for example, 2000–2025.
default: Instructs the router to use an existing default
•
COR list.
Exits call-manager-fallback configuration mode.
Configuring Call Handling
OL-13143-04