Cisco CP-7911G-CH1 System Administrator Manual page 155

Configuring Call Handling
Command or Action
Step 4
call application voice application-name
delay-time seconds
Example:
Router(config)# call application voice
transfer_app delay-time 1
Step 5
dial-peer voice number pots
Example:
Router(config)# dial-peer voice 25 pots
Step 6
application application-name
Example:
Router(config-dial-peer)# application
transfer_app
Step 7
exit
Example:
Router(config-dial-peer)# exit
Step 8
dial-peer voice number voip
Example:
Router(config)# dial-peer voice 29 voip
Step 9
application application-name
Example:
Router(config-dial-peer)# application
transfer_app
Step 10
exit
Example:
Router(config-dial-peer)# exit
Examples
The following example enables the H.450 Tcl script for analog transfer using hookflash and sets a delay
time of 1 second:
call application voice transfer_app flash:app-h450-transfer.tcl
call application voice transfer_app language 1 en
call application voice transfer_app set-location en 0 flash:/prompts
call application voice transfer_app delay-time 1
OL-13143-04
How to Configure Cisco Unified SCCP SRST
Purpose
(Optional) Sets the delay time for consultation call setup for
an analog phone that is making a call transfer using the
H.450 application. This command passes a value to the Tcl
script by using an attribute-value (AV) pair.
seconds: Number of seconds to delay call setup. Range
•
is from 1 to 10. Default is 2.
A delay of more than 2 seconds is generally noticeable to
users.
For more information about AV pairs and the Tcl script for
H.450 call transfer and forwarding, see the ReadMe file that
accompanies the script.
Enters dial-peer configuration mode to configure a POTS
dial peer.
Loads the application named in Step 1 onto the dial peer.
Exits dial-peer configuration mode.
Before exiting dial-peer configuration mode,
Timesaver
configure any other dial-peer parameters that
you need to set for this dial peer.
Enters dial-peer configuration mode to configure a VoIP
dial peer.
Loads the application named in Step 1 onto the dial peer.
Exits dial-peer configuration mode.
Before exiting dial-peer configuration mode,
Timesaver
configure any other dial-peer parameters that
you need to set for this dial peer.
Cisco Unified SCCP and SIP SRST System Administrator Guide
155