Configuring Backup Registrar Service To Sip Phones (Using Optional Commands) - Cisco CP-7911G-CH1 System Administrator Manual

How to Configure the SIP Registrar
Configuring Backup Registrar Service to SIP Phones (Using Optional
Commands)
The prior configurations set up a basic voice register pool. The configuration in this procedure adds
optional attributes to increase functionality.
Prerequisites
•
•
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
voice register pool tag
Example:
Router(config)# voice register pool 12
Cisco Unified SCCP and SIP SRST System Administrator Guide
112
Prerequisites as described in the
page 108.
Configuration of the required commands as described in the
to SIP Phones" section on page
enable
configure terminal
voice register pool tag
translation-profile outgoing profile-tag
alias tag pattern to target [preference value]
cor {incoming | outgoing} cor-list-name {cor-list-number starting-number [- ending-number] |
default}
incoming called-number [number]
number tag number-pattern {preference value} [huntstop]
dtmf-relay [cisco-rtp] [rtp-nte] [sip-notify]
end
"Configuring Backup Registrar Service to SIP Phones" section on
108.
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Enters voice register pool configuration mode.
Use this command to control which registrations are
•
accepted or rejected by a Cisco Unified SIP SRST
device.
Setting Up Cisco Unified IP Phones using SIP
"Configuring Backup Registrar Service
OL-13143-04