Configuration Mode - Cisco CP-7911G-CH1 System Administrator Manual

How to Configure the SIP Registrar
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Router# configure terminal
Step 2
voice register pool tag
Example:
Router(config)# voice register pool 1
Step 3
proxy ip-address
{ |
icmp-ping rtr} [alternate-ip-address
Example:
Router(config-register-pool)# proxy 10.2.161.187
preference 1 monitor probe icmp-ping
Step 4
end
Example:
Router(config-register-pool)# end
Step 5
show voice register dial-peers
Example:
Router# show voice register dial-peers
dial-peer voice 40035 voip
preference 5
destination-pattern 91011
session target ipv4:192.168.0.2
session protocol sipv2
voice-class codec 1
dial-peer voice 40036 voip
preference 1
destination-pattern 91011
session target ipv4:10.2.161.187
session protocol sipv2
voice-class codec 1
monitor probe icmp-ping 10.2.161.187
Cisco Unified SCCP and SIP SRST System Administrator Guide
118
[ ] [
preference value monitor probe
]]
Setting Up Cisco Unified IP Phones using SIP
Purpose
Use this command to enter global configuration
mode.
Use this command to enter voice register pool

configuration mode.

Set the proxy command to monitor with icmp-ping.
Returns to privileged EXEC mode.
Use this command to verify dial-peer
configurations, and notice that icmp-ping
monitoring is set.
OL-13143-04