Power Switch - Yamaha A4000 Owner's Manual

i
!0 !1 !2
(The A5000/A4000 also uses the button lamps to let you know
that it is receiving MIDI data. Each lamp corresponds to a differ-
ent MIDI data type, and will continue to blink while the A5000/
A4000 is receiving MIDI data of that type. (page 85))
o [F1] — [F6] Function buttons
Use these buttons to switch among the six functions within the
currently selected mode.
!0 [COMMAND/EXIT] button
This button calls the command menu from which you can access
a range of commands not included in the modes. Press a second
time to revert to the mode display. (page 177, 206)
!1 [ASSIGNABLE] button
This button can be used to turn off all notes, reset all controllers,
switch Knobs 2 through 5 for control change operation, switch
the function buttons for tone generator playback, and more.
(page 86)
!2 [AUDITION] button
Press the button to play out the currently selected sample. You
use this feature to check the sound of the sample while editing.
o
!3
!4
A5000
!3 Floppy-disk drive
Accepts a 3.5-inch floppy disk. You can use floppy disks to save
and reload your data (programs, samples, sequences, and system
settings).
Note that there is an access lamp at the lower left of the drive.
The lamp lights up while the disk is being accessed. Please do
not eject the floppy-disk while this lamp is on.
To eject a disk, press the EJECT button at the lower right of the
drive. (page 15)

!4 POWER switch

Press once to switch the power on. Press again to turn the power
off. (page 27)
• The A5000/A4000 stores all new data into main memory only, and
will lose all of this data when you switch off the power. You must
therefore be sure to save all important data to disk before turning
the A5000/A4000 off.
Panel and Connector Arrangement
A5000/A4000
11