Sample Information; Smpinfo - Yamaha A4000 Owner's Manual

EDIT-TRIM/LOOP
Knob 5
Same function as Cursor
CATCH cannot be executed.

Sample Information

[EDIT] Button [F1] Button
"EDIT-SmpInfo"
Sample Information provides access to a number of parame-
ters related to Trim/Loop editing. Also, the sample frequency
of the wave data is shown in Hertz on the left side of the dis-
play.
Knob 1 Knob 2
Turn
Page End Type
action
Press
Tree View —
action
Knob 1
[ Turn] Page
Selects display pages.
[ Press] Tree View
Calls the Tree View display (page 83).
Knob 2
[ Turn] End Type
Selects the type of indication used to show the end
address and the loop end address on the edit screen.
(Note that the start address and loop start address are
always shown by their absolute address values.)
[Range] address, length, time, beat
• address ... End and loop end addresses are indi-
cated by their absolute address values on the
waveform. (This is the standard setting.)
• length ... Each end address is shown by its dis-
tance from the corresponding start address, in
address increments.
• time ... Playback or loop time from the start
address or loop start address.
• beat ... Each end address is shown by its distance
in beats from the corresponding start address.
• When editing a sample bank "(---)" will appear and
this parameter cannot be edited.
124
Chapter 5 EDIT Mode
w
(page 121), except that E-
Knob 1 to select
Knob 3 Knob 4 Knob 5
Wave Start
Address
Loop Monitor Loop Tempo
Velocity
Sensitivity
— QUICK... CALCULATE
• A5000/A4000
Knob 3
[ Turn] Loop Monitor
Specifies the the number of milliseconds before the Loop
Start Address that loop monitor playback will begin.
[Range] -500ms — 0ms
• If you set the value to -500ms and then press the
knob, for example, the A5000/A4000 begins replay
from a point 1/2 second before the loop start. (This
lead-in is played only once, and does not recur after
the loop is entered.)
• When editing a sample bank "(---)" will appear and
this parameter cannot be edited.
Knob 4
[ Turn] Wave Start Address Velocity Sensitivity
This value sets the start-address velocity sensitivity: the
degree by which the start point varies in response to the
velocity (force) of the played note. This feature gives you
added control over the attack part of the playback.
[Range] -63 — +63
• A value of 0 leaves the start address constant for all
velocities. Positive values cause the start-point to
move forward (the address to get higher) at higher
velocities, and to move backward at lower velocities.
Negative settings have the opposite effect.
[ Press] QUICK...
Calls the quick entry menu (page 83).
Knob 5
[ Turn] Loop Tempo
This knob sets the tempo used to calculate the number of
beats between the start address and end address.
[Range] 80.0 — 159.9
[ Press] CALCULATE
If you push the knob, the A5000/A4000 automatically cal-
culates and displays the tempo value for you, based on
the assumption that the number of beats between the
current start and end addresses is 4 beats (or an even
multiple or dividend of 4 beats).
• When editing a sample bank "(---)" will appear and
this parameter cannot be edited.