Minolta DI450 Operator's Manual page 66

Hole Punch
<Only when the Finisher FN-5/ Finisher FN-105/
Mailbin Finisher is mounted>
1
Touch the desired finishing function key and
then touch [Hole Punch].
<For United States and Canada Users>
<Except United States and Canada Users>
NOTES
• Paper size
Finisher FN-5 :11 17L to Letter
Finisher FN-105 :11 17L to Letter
Mailbin Finisher :11 17L to Letter
• Hole Punch is not possible in the Interrupt
mode.
• When making copies in the Hole Punch mode,
make sure to load the originals into the
Electronic Document Handler or place the
Originals on the original Glass in the correct
direction. p.3-33
<For United States and Canada Users>
<Only when the Finisher FN-5 is mounted>
• The number of punch holes can be changed
between "2-Hole" and "3-Hole" by using the
Knob located inside the Finisher.
* When changing the setting for the number of
holes to be made, be sure the
aligned.
.
Pull out Knob: 2-Hole
Push in Knob: 3-Hole
* The number of punch holes can be graphically
identified on the Touch Panel.
4003P331EA
Useful Tips
• If you do not select a hole-punching position,
the machine automatically sets the Hole Punch
position according to the original feeding
direction as illustrated below.
4003P031DA
• When making copies from either the 11 17L or
Legal L size, the machine automatically
specifies the hole punching position as shown
below.
marks are
5. Selecting the Finishing
Knob
Copy
Orig.
Orig.
Copy
Copy
Orig.
3-23
4002O295EA
1155O789EA
1155O790EA
1155O791EA