SMC Networks 8606SX - annexe 2 User Manual page 41

Select an entry in the node list to display the Note and filename mapping for the selected node.
Each node in the BOOTP Server can have its own filename mapping list. This provides maximum
flexibility for the network administrator. Default mapping is also provided, where in most cases
per-node special mapping is not required. Click on the DEFAULT name to set both the IP and MAC
addresses to zero; this represents the default file mapping list.
To exit the BOOTP server, click on the Exit button.
Adding and Modifying Node Information
The BOOTP Server starts with a single entry called DEFAULT. No file
mapping is initially defined for this entry. To provide BOOTP service
based on generic information, add the entries you require to the file
map for the DEFAULT node. To service specific nodes, enter data for
each node.
To add a new node:
1. Click the Add Node button in the BOOTP Server dialog box. This
will bring up the Add Record dialog box.
2. Enter the following information in the record fields.
Parameters
Name
MAC Address
IP Address
Subnet Mask
Default Gateway
Note
3. Click OK to accept the changes or Cancel to abort them.
New node information appears in the node address list.
To modify a node:
1. Click on the required node in the node address list.
2. Click the Edit Node button.
3. Make any changes to the current information.
4. Click on OK to accept the changes.
Description
Node name. Enter up to 14 characters.
Physical address of the device.
IP network address.
This mask identifies the host address bits used for routing to
specific subnets.
The gateway must be defined if the device is not located in
the same IP segment as the BOOTP server.
Enter a note of 100 characters or less.
N T
ETWORK
Example
NetWare Server 2
0000E8C0A301
192.255.74.32
255.255.0.0
10.1.0.254
Backup file server at Bldg 100-34.4
OOLS
5-3