SMC Networks 8606SX - annexe 2 User Manual page 152

E M
RROR ESSAGES
IPX Diagnostic Service Socket open failure.
Cause: The network sublayer has a problem.
Action: Use the alive test program to verify.
No bitmap file information in [bitmaps] of NETMGR.INI.
Cause: Cannot find any bitmap file information in NETMGR.INI.
Action: Use a text editor to edit NETMGR.INI.
No device information in [device] of NETMGR.INI.
Cause: Cannot find any device information in NETMGR.INI.
Action: Use a text editor to edit NETMGR.INI.
None of the protocols are enabled, please use network setup to configure again.
Cause: The record in NETMGR.INI is not correct.
Action: You should enable at least one protocol; use the network setup program to configure again.
None of the SNMP/UDP or SNMP/IPX protocols work!
Cause: All protocols supported by discover.exe are not working.
Action: Check to see if your network subsystem is OK.
Not enough memory to allocate channel parameter structure.
Cause: Out of memory.
Action: Close some applications and try again.
Not enough memory to allocate for IPX packet data.
Cause: The memory is not enough.
Action: Close some applications and retry.
Open ICMP channel failure.
Cause: The ICMP network sublayer has failed.
Action: Memory may not be enough. Otherwise, use the alive test program to verify network
status.
Open IPX channel failure. IPX protocol will be disabled!
Cause: The IPX network sublayer has a problem or has returned a NULL IPX address.
Action: Restart Windows or start another ELITEVIEW SNMP or IPX application first.
Open SNMP/IPX channel failure.
Cause: The SNMP or IPX network sublayer has failed.
Action: Retstart Windows and retry.
Open SNMP/UDP channel failure.
Cause: UDP/IP network sublayer has failed.
Action: Use the alive test program to verify the ELITEVIEW platform. If based on a third-party
vendor's platform, make sure it is OK.
I-8