Terminator Card - Dell POWEREDGE 4300 Service Manual

Dell computer motherboard user manual

Hide thumbs Also See for POWEREDGE 4300:

Table of Contents

4-32

Dell PowerEdge 4300 Systems Service Manual

2. Remove the two retention pins from the SEC cartridge and heat sink

assembly (see Figure 4-28).

3. Pull the SEC cartridge straight up out of the connector and guide bracket

assembly (some force may be required).

To replace an SEC cartridge, make sure the cartridge release latches are in the

open position, orient the new SEC cartridge in the guide bracket assembly (as

shown in Figure 4-28) and seat it firmly, and then snap the release latches back

into place. Reinstall the two retention pins.

To install an SEC cartridge where there was none before, you will need to

remove the installed terminator card (see the next subsection, "Terminator

Card").

NOTE: Do not attempt to operate the system with the microprocessor set to a

speed other than the specified rating.

guide bracket

assembly

retention pins (2)

SEC cartridge

release latches (2)

heat sink

Table of Contents