Dell POWEREDGE 4300 Service Manual page 70

4-12 Dell PowerEdge 4300 Systems Service Manual
hard-disk drive
keylock
drive-carrier
handle
Remove a SCSI hard-disk drive from an internal drive bay as follows.
1. If the system does not have a PowerEdge Expandable RAID Controller card
installed, shut down the system and go to step 3.
2. For systems with a PowerEdge Expandable RAID Controller card, refer to
the RAID controller documentation for information on preparing the drive
for removal. When the drive has been powered down, wait until the drive
status indicators adjacent to the drive bay signal that the drive may be
removed safely.
If the drive has been online, the drive status indicators flash sequentially as
the drive is powered down. When all indicators are turned off, the drive is
ready for removal.
3. Unlock the hard-disk drive keylock (see Figure 4-9).
4. Squeeze the open side of the drive carrier handle to release it, open the
handle, and slide the carrier toward you until it is free of the drive bay.
drive carrier