Dell POWEREDGE 4300 Service Manual page 86

4-28 Dell PowerEdge 4300 Systems Service Manual
4. For the card you want to remove, press in and hold the clip on the back of
the computer. At the same time, from inside the computer, press the
curved release tab in the middle of the expansion-card latch toward the
bottom of the card. After the release tab clicks into the latch cutout, rotate
the latch away from the expansion-card bracket (see Figure 4-23).
expansion-
card latch
5. Release the inner end of the expansion card by pressing outward on the
latch at the inner corner of the card.
6. Grasp the expansion card by its corners and carefully remove it from the
expansion-card connector.
To install an expansion card, insert the card firmly into its connector and make
sure the securing clips on both ends of the card (when applicable) are in place.
Secure the clip on the back of the computer by pressing firmly inward until the
release lever on the inside clicks into place.
release tab
expansion card
PCI access door