This appendix describes the System Setup program, which is used to change
the system configuration information stored in NVRAM on the system board.
For in-depth information, refer to Chapter 4, "Using the System Setup Pro-
gram" in the Dell PowerEdge 4300 Systems User's Guide .
To enter the System Setup program, follow these steps:
1. Turn on (or reboot) the system.
2. Press <Ctrl><Alt><Enter> immediately after you see the message
If you wait too long, the operating system begins to load into memory, the
message disappears, and you cannot enter the System Setup program. Let
the system complete the load operation ; then shut down the system and try
again.
NOTE: To ensure an orderly system shutdown, consult the documentation
that accompanied the operating system.
.
System Setup Program
A-1