Dell POWEREDGE 4300 Service Manual page 50

3-10 Dell PowerEdge 4300 Systems Service Manual
Incorrect configura-
tion settings in
System Setup
program or no
operating system on
hard-disk drive
Defective system
board
Faulty diskette,
diskette/tape drive
subsystem, or
hard-disk drive
subsystem
No operating sys-
tem on diskette
Attempted to run
system with more
than 512 MB of
memory and only
one power supply
Attempted to run
two microproces-
sors with one
power supply
Attempted to run
more than one RAID
controller with one
power supply
Plug and Play or PCI
resource configura-
tion failure
Check the hard-disk drive
configuration settings in
the System Setup
program.
Replace the system
board.
Replace the diskette or
hard-disk drive. If the
problem persists,
replace the system
board.
Use a bootable diskette.
Install a PSPB with addi-
tional power supplies.
Install a PSPB with addi-
tional power supplies.
Install a PSPB with addi-
tional power supplies.
Reboot the system. If
the problem persists, run
the RCU to identify the
resource conflict and
then reallocate system
resources accordingly.