Removing The Front Fairing - APRILIA RS 125 TUONO - 2003 Manual

RS 125 Tuono_Ing_book_my03.book Page 59 Tuesday, April 29, 2003 3:11 PM
CLEANING
N Clean the filtering element (4) with clean,
non-inflammable solvents or solvents
with high volatility point, then let it dry
thoroughly.
N Apply a filter oil or a thick oil (SAE 80W-
90) on the whole surface of the filtering
element, then squeeze it to eliminate the
oil in excess.
The filtering element (4) must be
well impregnated, though not
dripping.
CHANGING
N Replace the filtering element (4) with a
new one of the same type.
2
1

REMOVING THE FRONT FAIRING

N Place the vehicle on the stand, see
page 47 (POSITIONING THE VEHICLE
ON THE REAR SUPPORT STAND
N Set the ignition switch to " ".
N Release and remove the two screws
(1) at the sides.
N Release and remove the two upper
screws (2).
On refitting, tighten the screw (2)
moderately, as it sits on plastic.
4
N Lean the front fairing (3) moderately
forward.
N Disconnect the connector of the wiring
(4).
).
N Remove the front fairing (3) complete
with headlight.
Make sure to refit the electrical
connector (4) to the matching
connector on refitting.
Handle plastic and paint-finished
parts with care to avoid scra-
tching or damage.
use and maintenance RS 125 Tuono
3
59