Adjusting The Vertical Headlight Beam - APRILIA RS 125 TUONO - 2003 Manual

RS 125 Tuono_Ing_book_my03.book Page 72 Tuesday, April 29, 2003 3:11 PM
ADJUSTING THE VERTICAL
HEADLIGHT BEAM
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
72
use and maintenance RS 125 Tuono
1
1
1
To adjust the headlight beam:
N Release and remove the three retaining
screws (1) of the inner cover (2).
N Remove the front fairing inner cover (2).
Handle plastic and paint-finished
parts with care to avoid scra-
tching or damage.
Note the position of the inner co-
ver (2) during removal and make
sure it becomes properly located
into its seat in the front fairing on refit-
ting.
2
3
N Working on the rear left side of the front
part of the fairing, adjust the appropriate
screw (1) by means of a short cross-tip
screwdriver.
By SCREWING IT (clockwise), you set
the beam upwards.
By UNSCREWING IT (anticlockwise),
you set the beam downwards.