Table of Contents
Advertisement
4.8.1 VPN Express Wizard - Policy Setting
The Policy Setting specifies which devices can use the VPN tunnel. Local and remote IP
addresses must be static.
Local Policy (IP/Mask): Type the IP address of a computer on your network. You can also
specify a subnet. This must match the remote IP address configured on the peer IPSec device.
Remote Policy (IP/Mask): Type the IP address of a computer behind the peer IPSec device.
You can also specify a subnet. This must match the local IP address configured on the peer
IPSec device.
Figure 36 VPN Express Wizard: Step 4
The following table describes the labels in this screen.
Table 17 VPN Express Wizard: Step 4
LABEL
Summary
Name
Secure
Gateway
Pre-Shared
Key
Local Policy This is a (static) IP address and Subnet Mask on the LAN behind your ZyWALL.
Remote
Policy
ZyWALL 1050 User's Guide
DESCRIPTION
This is the name of the VPN connection (and VPN gateway).
This is the WAN IP address or domain name of the remote IPSec router. If this field
displays 0.0.0.0, only the remote IPSec router can initiate the VPN connection.
This is a pre-shared key identifying a communicating party during a phase 1 IKE
negotiation.
This is a (static) IP address and Subnet Mask on the network behind the remote
IPSec router.
Chapter 4 Wizard Setup
97
Advertisement
Table of Contents
Troubleshooting
