Table of Contents
Advertisement
Chapter 44 System Remote Management
The following table describes the labels in this screen.
Table 207 System > SSH
LABEL
Enable
Version 1
Server Port
Server
Certificate
Service Control
#
Zone
Address
Action
Add icon
Apply
Reset
44.7 Secure Telnet Using SSH Examples
This section shows two examples using a command interface and a graphical interface SSH
client program to remotely access the ZyWALL. The configuration and connection steps are
similar for most SSH client programs. Refer to your SSH client program user's guide.
44.7.1 Example 1: Microsoft Windows
This section describes how to access the ZyWALL using the Secure Shell Client program.
1 Launch the SSH client and specify the connection information (IP address, port number)
for the ZyWALL.
2 Configure the SSH client to accept connection using SSH version 1.
3 A window displays prompting you to store the host key in you computer. Click Yes to
continue.
596
DESCRIPTION
Select the check box to allow or disallow the computer with the IP address that
matches the IP address(es) in the Service Control table to access the ZyWALL
CLI using this service.
Select the check box to have the ZyWALL use both SSH version 1 and version 2
protocols. If you clear the check box, the ZyWALL uses only SSH version 2
protocol.
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the certificate whose corresponding private key is to be used to identify the
ZyWALL for SSH connections. You must have certificates already configured in the
My Certificates screen (Click My Certificates and see
details).
This specifies from which computers you can access which ZyWALL zones.
This the index number of the service control rule.
This is the zone on the ZyWALL the user is allowed or denied to access.
This is the object name of the IP address(es) with which the computer is allowed or
denied to access.
This displays whether the computer with the IP address specified above can
access the ZyWALL zone(s) configured in the Zone field (Accept) or not (Deny).
Click the Add icon in the heading row to open a screen where you can add a new
rule. Refer to
Table 206 on page 586
Click the Edit icon to go to the screen where you can edit the rule.
Click the Add icon in an entry to add a rule below the current entry.
Click the Delete icon to remove an existing rule. A window display asking you to
confirm that you want to delete the rule. Note that subsequent rules move up by
one when you take this action.
Click the Move to N icon to display a field to type a number for where you want to
put that rule and press [ENTER] to move the rule to the number that you typed.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Chapter 40 on page 539
for information on the fields.
ZyWALL 1050 User's Guide
for
Advertisement
Table of Contents
Troubleshooting
