Table of Contents
Advertisement
You must subscribe to services on the backup ZyWALL before synchronizing it
with the master ZyWALL.
33.6.2 Synchronize Screen
Use this screen if you want the ZyWALL to get or to send updated IDP signatures, and
configuration information in the virtual router.
You can only set up synchronization with other ZyWALLs of the same model
running the same firmware version.
To access this screen, click Network > Device HA > Synchronize.
Figure 365 Network > Device HA > Synchronize
For synchronization, every ZyWALL in a virtual router should usually have the same
Password, Synchronize From, and on port values. In addition, the management IP address
must be in the same subnet as the interface (in other words, the virtual router). The following
table describes the labels in this screen.
Table 154 Network > Device HA > Synchronize
LABEL
Password
Synchronize
From
on port
ZyWALL 1050 User's Guide
DESCRIPTION
Enter the password used to verify other ZyWALL routers during synchronization.
This password is different than the one that is used for authentication in the VRRP
group. Every ZyWALL in the virtual router must use the same password. If you
leave this field blank, the password returns to its default setting "1234".
Enter the IP address or fully-qualified domain name (FQDN) of the router from
which to get updated configuration and IDP signatures. Usually, you should enter
the IP address or FQDN of a virtual router on a secure network.
Enter the Secure FTP port number used by the ZyWALL you specified in
Synchronize From. Usually, every ZyWALL in the virtual router should use the
same port number. Otherwise, if the master ZyWALL changes, you might have to
change this port number.
Chapter 33 Device HA
497
Advertisement
Table of Contents
Troubleshooting
