Reboot; Figure 479 Maintenance > Reboot - ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 User Manual

C
H A P T E R
Use this to restart the device (for example, if the device begins behaving erratically). See also
Section 1.4 on page 53
If you applied changes in the Web configurator, these were saved automatically and do not
change when you reboot. If you made changes in the CLI, however, you have to use the
command to save the configuration before you reboot. Otherwise, the changes are lost
write
when you reboot.
Reboot is different to reset; (see
default configuration.
The Reboot screen is part of the Web configurator so that remote users can restart the device.
To access this screen, click Maintenance > Reboot.
Figure 479 Maintenance > Reboot
Click the Reboot button to restart the device. Wait a few minutes until the login screen
appears. If the login screen does not appear, type the IP address of the device in your Web
browser.
You can also use the CLI command
ZyWALL 1050 User's Guide
for information on different ways to start and stop the ZyWALL.
Section 50.2 on page
to restart the device.

reboot

49
Reboot
646) reset returns the device to its
643