The Wan Port Leds; The Console Port; Table 72 Troubleshooting The Wan Led; Table 73 Troubleshooting Console Port - ZyXEL Communications VSG-1200 User Manual

VSG-1200 User's Guide

26.1.3 The WAN Port LEDs

None of the LEDs for the WAN port light up when connected to an Ethernet device.

Table 72 Troubleshooting the WAN LED

STEP CORRECTIVE ACTION
1 Verify that the attached device(s) is turned on and properly connected to the VSG.
2 Verify that Ethernet cable length does not exceed 100 meters.
3 Make sure the network adapters are working on the attached devices.

26.2 The Console Port

I cannot access the VSG through the console port.

Table 73 Troubleshooting Console Port

STEP CORRECTIVE ACTION
1 Check to see if the VSG is connected to your computer using a console cable.
2 Check to see if the communications program is configured correctly. Set the communication
parameters as stated here.
•
•
•
•
3 Make sure you entered the correct username and password. The default administrator
username is "admin" and the default password is "1234". The username and password are
case sensitive.
If you have forgotten the administrator user name and/or password, you must reset the VSG
back to the factory defaults using the reset button. Use a pointed object to press the reset
button on the front panel to reset the VSG. All your custom configuration will be lost.
212
Emulation: auto detect
Baud Rate: 9600 bps
No Parity, 8 data bits, 1 stop bit
Flow Control: None
Chapter 26 Troubleshooting