Figure 132 Smt: System Configuration; Table 63 Smt: System Configuration - ZyXEL Communications VSG-1200 User Manual

Figure 132 SMT: System Configuration

System Name
Doamin Name
Console Port Speed
Web Server Port
E-Mail Server Redirect
The following table describes the fields in this menu.

Table 63 SMT: System Configuration

FIELD
System Name
Domain Name
Console Port
Speed
Web Server Port
E-mail Server
Redirect
At the "S)ave and return R)eturn without saving M)odify:" prompt, type S and press [ENTER] to save the
changes and return to the previous screen, type R and press [ENTER] to discard all changes and return
to the previous screen or type M and press [ENTER] to continue configuring the fields. Restart the
device when prompted
Press [ESC] and enter Y to stop any actions in the current screen and return to the previous screen. All
changes will be discarded.
Chapter 23 The SMT
System Configuration
:
:
:9600
:80
:
DESCRIPTION
Enter a descriptive name (up to 32 characters) for identification purposes.
Enter the domain name (if you know it) here. If you leave this field blank, the VSG
may obtain a domain name from a DHCP server.
The domain name you entered is given priority over the DHCP server assigned
domain name.
Enter 1200, 2400, 4800, 9600, 14400, 19200, 38400, 57600, or 115200 to set the
console port speed.
The default setting is 9600.
Note: If you change the console port speed, make sure you also
make the same change to the terminal emulator software.
Specify the port number of the embedded web server on the VSG to access the
web configurator. The default port number is 80.
Enter a number between 8010 and 8060 to access the web configurator behind a
NAT-enabled network.
If you enter a number between 8010 and 8060, you need to append the port
number to the WAN or LAN port IP address to access the web configurator. For
example, if you enter "8010" as the web server port number, then you must enter
"http://www.192.168.1.1:8010" where 192.168.1.1 is the WAN or LAN port IP
address.
Enter the IP address or domain name of the e-mail server to which the VSG
forwards e-mail. This field should be configured if the e-mail server is behind a
firewall or on a NAT-enabled network.
VSG-1200 User's Guide
187